MEMS
B&K Type 4570 Accelerometer DC Response, 500G, 4 MV/G, Integral Open Ended Cable
The DC Response Accelerometers are designed to measure low-frequency vibration down to DC. The gas- damped sensing element offers a wide dynamic range and very stable frequency response even after subjection to high shock levels.
USE SCENARIOS
- Low-frequency, motion and tilt measurements
- Flight testing
- Road load testing
- Transportation
- Modal analysis
The accelerometer has built- in conditioning, where the sensing element and electronics are shielded, sealed and insulated from the housing.
D-versions are available offering high thermal stability from –55 to +121°C.
Frequency range: 0 – 1850 Hz
Temperature: -55 – 121 C
Weight: 8 gram
Sensitivity: 0.4 mV/ms^-2
Residual Noise Level in Spec Freq Range (rms): ±150 mg
Maximum Operational Level (peak): 500 g
Accessory Included: Hex Wrench
Clip/Stud/Screw included: Cap Screws, Washers
Output: Piezoresistive
Unigain: No
Triaxial: No
TEDS: No
Applications: Modal
Unit: mV
Resonance frequency: kHz
Maximum Shock Level (± peak): 10000 g